 |
 |
 |
|
The Original Rapid Tac
For fast, easy, quality installation of graphics with no bubbles, even in cold weather.
This environmentally friendly product is great for installing decals and vinyl graphics.
Granted, not all applications call for a "wet" procedure, but we do know that in most applications, forty to sixty percent labor time can be saved by using an application fluid. Sometimes one person can do a job (normally requiring two people to apply dry) in less time if an application fluid like Rapid Tac or new Rapid Tac II is used. (Rapid Tac II bonds faster than Rapid Tac, and is intended for films with a lower tac adhesive than premium vinyl.)
Application fluid cleans without leaving residues. It then helps to "float" the vinyl until it is properly positioned. Best of all Rapid Tac and Rapid Tac II stimulates the adhesive to bond in approximately ninety seconds, even in adverse climates such as extreme hot or cold. It will not cause bubbles so there's no returning to poke holes in your work either. Your customers and your reputation will benefit from higher-quality applications.
STEP 1. Clean surface thoroughly with Rapid Tac/Rapid Tac II and a kitchen paper towel. DO NOT USE OTHER CLEANERS OR SOLVENTS.
(We do recommend Rapid Prep as a pre-cleaner for surfaces that may have been exposed to wax, silicone, or other suspected contaminants)
STEP 2. Spray surface again with Rapid Tac/Rapid Tac II. Peel backing off decal and place on wet surface.
STEP 3. Position decal. Use squeegee to remove fluid, using a good deal of pressure and working from the center out to the edges in all directions.
STEP 4. Wait 2-3 minutes. Saturate paper cover tape, if any, with Rapid Tac/Rapid Tac II, then remove paper tape. Wipe surface with paper towel. |
|
|
|
|
|
|
|
|
