 |
 |
 |
|
| Once you get your tape tool clamped or bolted to your table or work bench, you simply pull your application tape out, over and just past the end of your vinyl. You can adjust the tension of your tape coming off the roll with a quick turn of the tensioning knob. Once you get your tape out and over your vinyl, you simply fasten the application tape to your table and squeegee it down back towards the roll of application tape. The tension that you set with the clutch keeps your application tape up and off your vinyl until you squeegee it down. * You can place one or more rolls of tape up to 48'' onto each of the 2 shafts. * The end support mounting brackets when they are fastened to your table are 3 inches wider than the tape tool. |
|
|
|
|
|
|
|
|
